#CODED UI BROWSER CONTROL LOCATIONS OFF SERIAL#
#CODED UI BROWSER CONTROL LOCATIONS OFF SOFTWARE#

You can run the wizard after you receive the switch from the factory or after the switch has been reset to factory defaults. The configuration wizard enables you to configure basic settings on the switch. The valid range is from 1 to 86400 connections. The valid range is from1 to 86400 seconds.Д®nter the maximum number of connection requests that the server can accept in the Maximum number of Requests (1 to 86400) text box. The valid range is from 1 to 600 seconds.Д®nter the server life time in the Server Life Time (1 to 86400 sec) text box. Secure web mode (HTTPS) is a secure connection.Д¬hoose to track the device in the IP Device Tracking check box.Д¬hoose to enable the trust point in the Enable check box.Д¬hoose the trustpoints from the Trustpoints drop-down list.Д®nter the amount of time, in seconds, before the web session times out due to inactivity in the HTTP Timeout-policy (1 to 600 sec) text box. To enable secure web mode, which allows users to access the switch GUI using вЂњ choose Enabled from the HTTPS Access drop-down list. Web mode (HTTP) is not a secure connection. To enable web mode, which allows users to access the switch GUI using вЂњ choose Enabled from the HTTP Access drop-down list. The HTTP-HTTPS Configuration page appears. Now, the switch is configured with the IP address for service port.Д¬hoose Configuration > Switch > Management > Protocol Management > HTTP-HTTPS. Specify the IP address for the service port which is the gigabitethernet 0/0 interface.ДЄfter entering the configuration parameters in the configuration wizard, you can access the Web GUI. Proceed with basic initial setup configuration parameters in the CLI setup wizard.

If the switch passes the power-on self-test, the bootup script runs the configuration wizard, which prompts you for basic configuration input.Д®nter yes.

#CODED UI BROWSER CONTROL LOCATIONS OFF SOFTWARE#

The bootup script displays operating system software initialization (code download and power-on self-test verification) and basic configuration.

Plug the AC power cord into the switch and a grounded 100 to 240 VAC, 50/60-Hz electrical outlet.

#CODED UI BROWSER CONTROL LOCATIONS OFF SERIAL#

Before you can configure the switch for basic operations, you need to connect it to a PC that uses a VT-100 terminal emulation program (such as HyperTerminal, ProComm, Minicom, or Tip).Д¬onnect one end of a null-modem serial cable to the switch's RJ-45 console port and the other end to your PC's serial port.

Coded ui browser control locations off